Service manual

68. Pull the fusing unit [A] halfway out. Remove the left fusing cover [B] and

open the oil tank cap [C].

69. Pour in the silicone oil [D].

NOTE: Never fill the silicone oil tank over the MAX line. Otherwise, the

silicone oil may overflow.

70. Put back the oil tank cap and reinstall the fusing unit into the copier. Then

close the front cover.

NOTE: Be sure to push on the fusing unit handle [E] when reinstalling

the fusing unit. Do not push the fusing knob [F]; the fusing unit

may be damaged.

CAUTION :

Be careful that the silicone oil does not spill onto the floor. If the

silicone oil spills onto the floor, be certain to wipe it away completely

with a solvent. Spilled silicone oil presents a slip hazard.

71. When the platen cover is to be installed:

Install the platen cover [G] as shown (2 stepped screws [H]).

When the ARDF is to be installed:

Install the ARDF by following the procedure shown in the installation

section for the ARDF.

[G]

[H]

[A]

[B]

[C]

[D]

[E]

[F]

COPIER INSTALLATION

A166/A187/A189 3-30 SM

CÓPIA NÃO CONTROLADA