Service manual

62. Rotate the revolver until the Bk toner hopper [A] is positioned as shown.

Remove the shutter [B] from the hopper. Shake the black toner cartridge

10~15 times and install the Bk toner cartridge [C] completely into the

development unit. Remove the Bk toner cartridge seal [D].

NOTE: 1) Be sure to rotate the revolver counterclockwise while keeping

the toner supply motor unit away from the revolver.

2) When removing a shutter, be sure to rotate the revolver until

the opening faces up. Do not remove a shutter if its opening

is not facing up, or any remaining toner will spill out.

63. Remove the Y toner shutter [E] from the hopper. Shake the yellow toner

cartridge 10~15 times and install the Y toner cartridge [F] completely into

the development unit. Remove the seal [G].

[C]

[B]

[A]

[D]

[E]

[H]

[F]

[G]

COPIER INSTALLATION

A166/A187/A189 3-28 SM

CÓPIA NÃO CONTROLADA