Service manual

52. Reinstall the following parts using the reverse procedure of their removal:
•
Drum stay (Install in the following order, to avoid damaging the drum
stay: 1 drum securing spring, [LD shield plate: 220/240 V machine
only], 1 connector, the drum stay, 1 knob screw, 1 ID sensor shield
plate screw, 1 drum stay screw, and 1 final 2 connectors).
•
Charge corona unit (1 screw).
53. Reinstall the following parts by the reverse procedure of their removal.
•
Transfer belt unit
•
Transfer belt stay (3 screws, 3 connectors and 1 clamp)
•
Paper transfer corona unit
NOTE: When reinstalling the paper transfer corona unit [B], be sure that
it fits securely onto the rail [A]. Also ensure the belt tension
release lever is placed in the upper position during reinstallation.
54. Remove the screw [C] and turn the belt tension release lever [D]
counterclockwise as shown. Then tighten the belt tension release lever at
the contact position with the same screw [C].
55. Reinstall the belt transfer corona unit [E] (1 snap ring).
NOTE: Before reinstalling the belt transfer corona unit [E], be sure that
you have attached the belt tension release lever [D] at the
contact position. Otherwise, the edge of the belt transfer corona
unit may damage the transfer belt.
[B]
[A]
[D]
[C]
[E]
[D]
Installation
Procedure
COPIER INSTALLATION
SM 3-25 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA