Service manual

43. Remove the transfer belt unit [A]. Then remove the paper and strip of
tape [B] attached to the transfer belt.
NOTE: 1) When removing the transfer belt unit, be sure to hold the
chain [C] with your left hand and hold the bottom bracket [D]
with your right hand, as shown. This prevents your fingers
from touching the transfer belt surface. If the transfer belt
surface is touched with your bare hands, copy quality
problems may be caused by the skin oil deposited on the belt.
2) While removing the transfer belt unit from the copier, do not
turn the toner collection pipe counterclockwise [F] (as viewed
from the front of the machine).
44. Remove the transfer belt release wedges [E] from the transfer belt unit (one
M4 X 6 screw for each).
NOTE: Keep the transfer belt release wedges [E] and their securing
screws after installing the machine. They will be re-used if the
machine is moved to another location in the future. The wedges
are also used as a tool in transfer belt replacement.
[A]
[D]
[B]
[C]
[E]
[E]
[F]
COPIER INSTALLATION
A166/A187/A189 3-22 SM
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA