Service manual

16. Place the development unit on a clean sheet of paper as shown above
(development unit placement position).
NOTE: Be sure to use a clean sheet of paper or floor mat when placing
the development unit on the floor. This prevents the floor from
getting dirty.
17. Rotate the development unit into the developer installation position as
shown, and remove the toner catch plate [A] (2 screws). Then, remove
the revolver retaining foam block [B].
NOTE: Keep the cushion after installing the machine. It will be re-used if
the machine is moved to another location in the future.
18. Reinstall the toner catch plate [A] (2 screws).
19. Rotate the development unit back into the development unit placement
position. Turn the revolver counterclockwise until the locking lever
secures the revolver unit.
Development unit placement position
[B]
[A]
Developer installation position
Installation
Procedure
COPIER INSTALLATION
SM 3-15 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA