Service manual

1.2 ENVIRONMENT
To ensure the optimum copy quality, the following environmental
requirements need to be observed. When installing this copier at the
customer site, make sure that the location meets the following requirements.
1.2.1 Environmental Requirements
1. Avoid an area which is exposed to direct sunlight or is excessively
illuminated (the illumination should not exceed 2000 lux).
2. Avoid an area which is too hot and humid or too cold and dry.
Standard temperature range: 10°C to 32°C
Standard humidity range: 15% to 90%
Limit of high temperature and humidity: 30°C/90% or 32°C/80%
3. Avoid an area near fire or heat.
4. Avoid an area which is exposed to sudden temperature changes. This
includes areas where the machine will not be directly exposed to:
1) Cool air from an air conditioner
2) Heat from a heater.
5. Avoid a dusty area (maximum allowable amount of dust: 0.15 mg/m
3
).
6. Avoid a poor-ventilated area (required minimum ventilation: 30 m
3
/hr/man
7. Do not place the machine where it will be exposed to corrosive gases.
8. Place the machine on a level floor (the inclination on any side should be
no more than 5 mm).
9. Do not place the machine where it may be subjected to strong vibrations.
10. Do not install the machine at any location over 2,000 m (6,500 feet)
above sea level.
11. If the machine is installed close to other electronic equipment, they may
interfere with each other. To avoid this problem:
1) Keep the machine as far away as possible from any receiving devices
such as television sets or radios.
2) Reorient the receiving antenna of television sets and radios as
needed.
3) Use a separate dedicated outlet for the machine.
INSTALLATION REQUIREMENTS
A166/A187/A189 3-2 SM
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA