Service manual

11.2.2 Edit Mode
The process for copying is the same but the image data route for the display
editor is different from normal copy mode.
1. The SCU detects the edit command from the operation panel.
2. The SCU sends the scan command and requests the scanner unit for
image data to display.
3. The scanner IPU sends the image data for display to the SCU through
the printer unit. Then, image data is displayed on the LCD.
4. After the editing information has been entered at the LCD, this
information is sent to the scanner IPU board and stored in the memory
on the board.
5. After the Start key has been pressed, the machine performs its normal
routine and the editing information is mixed with the current image data
in the scanner IPU board. The mixed data is sent to the printer unit.
Detailed
Section
Descriptions
SYSTEM CONFIGURATION
SM 2-143 A166/A187/A189
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA