Service manual

8.3.4 By-pass Feed Paper Width Detection

The by-pass paper width detection board [A] monitors the paper width. The

rear side fence is connected to the terminal plate [B]. When the side fences

are positioned to match the paper width, the terminal plate slides along the

wiring patterns on the detection board. The patterns for each paper width on

the paper width detection board are unique. Therefore, the machine

determines which paper width has been placed in the by-pass feed table by

the signal output from the board.

This machine does not have a paper length sensor, so the paper length is

selected by user operation when the by-pass feed table is opened. (The user

also selects the lengthwise/sideways orientation.) The default of the

orientation is defined by SP 5-19-15.

The user also can select a non-standard paper size which was previously set

with a user tool (default: 432 x 297 mm).

[A]

[B]

LT version

A4 version

Detailed

Section

Descriptions

PAPER FEED AND REGISTRATION

SM 2-121 A166/A187/A189

CÓPIA NÃO CONTROLADA