Instruction manual

WARNING
FAILURE TO CAREFULLY OBSERVE THE
FOLLOWING INSTRUCTIONS COULD
RESULT IN SEVERE EQUIPMENT DAMAGE.
735348S-001 Rev.
August 28, 2009
7. Plug the VENDAPIN, LLC machine harness mini-Dsub 15 position connector to J2 on the Raptor II
VMC controller. Ensure the mounting screws are tight. See Figure 2.
Figure 2
8. Route the VENDAPIN, LLC machine harness out of the bottom of the enclosure as shown in the
following photos. Use the supplied strain relief to secure the harness in the exit hole. Figure 3 is for
an XL box and figure 4 is for an SL box.