Service manual

Symptoms, Causes, and Solutions of Bad Images
M000/M009 4-6 SM
4.2.5 LIGHT IMAGE
Description:
The printed image is light, with no ghost.
Symptom and Cause Solution
1. Develop roller is stained when the print
cartridge toner is almost consumed.
2. Ambient temperature is below 10°C.
3. Bad contact caused by toner stains
between high voltage terminal in the
HVPS and the one in the set.
4. Abnormal output from HVPS. (Run
self-test and check 1 to 4)
5. Check warranty out.
1. Check if the Toner Save mode is off.
Check if the density light is lit.
2. No 1: Replace the print cartridge and
try to print out.
3. No 2: Wait 30 minutes after printer is
powered on before you start printing.
4. No3: Clean up the area contaminated
with toner.
5. Replace the HVPS if the problems are
not solved by the above four
instructions.
CÓPIA NÃO CONTROLADA
CÓPIA NÃO CONTROLADA