Setup guide

ScanRouter V2 Professional/Enterprise Delivery System

❒ When communicating with G4, TID (Transmitting IDentifier) is used in-

stead of TSI. TID is similar to CSI(Own Fax Number) when communicating

with G3.

❒ When a fax delivering ID is specified, a document will be delivered to the

destination registered with the ID. (This method has priority over the TSI

method.)

❒ When a destination is not registered for a TSI in the TSI table, a fax docu-

ment with the TSI will be sent to the fax in-tray.

Reference

⇒ p.32 “Delivery Table Settings”

⇒ p.38 “Administering TSI Codes”

For information about a facsimile, see the operating instructions that come

with the device.

Fax in-tray

Documents received by fax will be sent to the fax in-tray except in the following

cases:

• When a fax delivering ID was specified when a fax was sent

• When a destination is registered with the TSI specified by a sender

Depending on the device, the in-tray created as the destination can be set for

each fax port as a fax in-tray during I/O device setting.

Note

❒ A delivery method can be specified for the fax in-tray in the same manner as

for other destinations.

❒ Each of the received fax documents can be delivered to the specified destina-

tion as a backup.

Reference

⇒ p.4 “Available delivery methods”

⇒ p.29 “Set Delivery Feature Defaults”