Setup guide

Notes
• Specifying source folder
Specify a folder that holds DeskTopBinder data.
You can specify one of the following as a source folder:
• A folder that was used as a DTB-Shared folder.
• A folder that holds DeskTopBinder data extracted from backed up data
(self-extracting format).
• A folder that holds DeskTopBinder data that have been left unconverted when
DeskTopBinder V2 is installed as co-existing installation. Specify the folder in
the following format: x:\RD, where x indicates drive letter.
• Specifying destination folder
Specify a folder where converted data will be stored.
You can specify any folder as destination except the following:
• Root of drive (such as C:\ or D:\)
• Windows folder (including Desktop folder) or Program Files folder.
• Any folder inside the RDCab folder.
• A folder in a drive whose free disk space is less than 50 MB. (Check the source
folder size and make sure that the destination drive has enough disk space.)
• A folder that contains files or folders.
You can create a new folder as destination by typing a new name into the
destination folder name box.
• Canceling Conversion
You can cancel a conversion at any time; however, you cannot resume it from the
point you interrupted. You have to start all over again.