Setup guide

Installing
5
2
J
JJ
J
Specify the location of the documents that DeskTopBinder V2 Professional
will manage, and then click [Next].
You can change the location of documents managed by DeskTopBinder V2
Professional, but generally leave them as they are and use the RDCab folder,
the stored location folder.
In the RDCab folder, the PL folder is created. The RDCab folder must be cre-
ated in the built-in hard drive of client computers where DeskTopBinder V2
Professional is installed.
Note
❒ If DeskTopBinder V2 Lite or DeskTopBinder V2 Professional was installed
on a client computer, the save location used in DeskTopBinder V2 Lite or
DeskTopBinder V2 Professional will be displayed as the default. If you
want to continue using the cabinet used with DeskTopBinder V2 Lite or
DeskTopBinder V2 Professional, do not change the save location.
K
KK
K
Confirm the setup details of the installation location, and then click [Next].
A registration confirmation dialog box for Auto-addition Tool startup ap-
pears.
L
LL
L
Click [Yes] to use the tool as a terminate-and-stay-resident tool or click [No]
to start it from the application.
M
MM
M
Click [Finish].
N
NN
N
The installation of ScanRouter V2 Link continues.
O
OO
O
Restart the computer.
If Auto-addition Tool is registered for startup, a confirmation dialog box for
starting Auto-addition Tool appears when you restart the computer.
P
PP
P
Click [OK].
The [Auto-addition Tool Properties] dialog box appears.
Q
QQ
Q
Make the necessary settings, and then click [OK].