Setup guide

Maintenance
45
3
Maintenance
The ScanRouter V2 Administration
Utility has the following maintenance
functions. Make sure that delivery
service is suspended before begin-
ning maintenance.
• Back Up
• Restore
• Recover
• Return to Installation Defaults
• Synchronize with Directory Server
(only with ScanRouter Enterprise)
Backing Up and Restoring
All system information can be backed
up in any directory on the delivery
server. It is recommended that back-
ups be made regularly.
To restore backup data, use the Re-
store function. Unnecessary backup
data may be deleted with the Delete
Backup Data function.
Note
❒ To make backups, use the Scan-
Router V2 Administration Utility
configured on the delivery server.
❒ In [Set Preferences] in the [Server]
menu, the day of the week and the
saving location can be specified for
the automatic backup.⇒ p.28
“Schedule”
❖
❖❖
❖ Backing Up
Select [Back Up] from the [Mainte-
nance] menu to save to the backup
directory. If there is an error
caused by insufficient disk space
during backup, change the backup
location or delete unnecessary
files, and then back up again.
❖
❖❖
❖ Restoring Backup Data
Select [Restore] from the [Mainte-
nance] menu, and then select the
backup data to use.
Important
❒ The Restore function should
only be used when there is no
alternative.
❒ The Restore function returns the
system to the state it was in
when the backup was made. All
data or changes saved since the
backup will be lost.
❖
❖❖
❖ Deleting Backup Data
Select [Delete Backup Data] from the
[Maintenance] menu, and then select
the data to delete.
Note
❒ When backing up or restoring
the system, do not perform any
other operations.
System Recovery
If the delivery server loses power for
any reason other than a regular shut-
down, data may be corrupted. If this
happens, the system may become un-
stable and cause frequent errors. To
resolve the situation, select [Recover]
from the [Maintenance] menu.
Important
❒ Do not use the Recover function
unless absolutely necessary.