Specifications

INSTALLATION OF THE HPGL/2 PLOTTER
Installation of the HPGL/2 plotter
Before using PLOTCLIENT HDI/ADI with AutoCAD 13/14, an
HPGL/2 plotter [HP DesignJet 1055 CM] has to be installed.
This installation is described in the two sections below.
Installation in AutoCAD 13
1. Start AutoCAD 13 and open the configuration dialogue
under the menu point "Options – Configure".
2. Press "Return" once.
3. Choose option 5 "Configure Plotter" and press "Return" to
confirm.
4. Choose option 1 "Add A Plotter Configuration" and press
"Return" to confirm.
5. Choose option 11 "HP-GL/2 Device" and press "Return" to
confirm.
6. Choose option 1 "HP DesignJet 1055 CM" and press "Re-
turn" to confirm.
7. Press "Return" once.
8. Choose the option "Parallel Port" and press "Return" to con-
firm.
9. Press "Return" to confirm the port name.
10. Confirm your changes in the next step with "Yes".
11. Answer the question about changing the parameters with
"No".
12. Answer the question about calibrating the printer with "No".
13. Answer the question "Write The Plot In A File" with "Yes".
14. Choose the required unit of measurement and press "Re-
turn" to confirm.
15. Press "Return" to confirm the defaults in the next step.
16. Press "Return" to confirm the defaults again in the next step.
17. Leave the rotation setting at "0" and press "Return" to con-
firm.
18. Answer the question "Remove Hidden Lines" with "No".
19. Choose the option "Fit" [on paper] and press "Return" to
confirm.
20. Leave the plotter name as the default and press "Return" to
confirm.
21. Choose the option "0" to leave the configuration.
RW-480 CLIENTS 91