Specifications

CONFIGURATION
"Job Processing" tab
• Sample Print
Activate this option, if you wish to test the quality of a print. Only
the first set of copies is printed. The print out of further sets of
copies is stopped so that you can check the quality of the print.
So you will go to the server and plot it. Then you decide whether
to continue or to cancel the plot according to message display.
Note: The "Sample Print" option may be disabled au-
tomatically by RW-480 PLOTBASE if the "Document
Server" option is selected.
• Delete after Plot
If you activate this option, the job is deleted after printing.
• Locked Print
By confirming the "Options" button, a dialog is displayed in
which the user is requested to enter a password twice. After this,
the print out can only be started at the server RW-480
PLOTBASE, if the correct password has been entered. For the
password, more than 32 characters can be accepted, however,
it is recommended to use 4 to 32 characters!
• Page Order
Here you can choose from three options of pages to be printed
– standard, reverse, auto:
standard: The set entries are printed out in the order they are
shown in the job editor ( 1, 2, 3 ... ). The order of the sheets in
the resulting stack depends on the selected output tray: If the
"front" tray is selected, the order of the sheets in the stack is the
same as the print order: 1, 2, 3,4 ... If the "rear" tray is selected,
the order of the sheets in the stack is reversed: ... 4, 3, 2, 1.
reverse: The set entries are printed out in reverse order ( ... 4,
3, 2, 1 ). The order of the sheets in the resulting stack depends
on the selected output tray: If the "front" tray is selected, the or-
der of the sheets in the stack is the same as the print order: ...
4, 3, 2, 1 If the "rear" tray is selected, the order of the sheets in
the stack is reversed again. The result is the original: 1, 2, 3, 4
RW-480 CLIENTS 82