Specifications

PEN SETTINGS
Calcomp - Misc
• Pen Source
If you activate the field "File", you tell the plotter that the printout
should use the pen thickness entered in the plot file belonging to
the entry, and not the settings on the card "Pen". If no pen
widths are defined, the program uses your settings.
If you activate "Custom" your settings are always used.
• Pen Scale
Activate this field if the pen widths are to be scaled at the same
time as a drawing is scaled. To avoid the possible loss of infor-
mation when printed ensure that have set at least one minimum
pen width if the drawing is to be reduced in size and at least
one maximum pen width, if the drawing is to be enlarged by
scaling.
• Ignore pen widths
Activate this option, e.g. if a drawing is exactly the same size as
a ISO A4 sheet, to guarantee that it is plotted on an A4 sheet
and not on the next larger format because the pen widths were
too large causing the drawing to slightly exceed the A4 format,
thereby causing unnecessary waste paper.
RW-480 CLIENTS 66