Specifications

STAMP EDITOR
- Translucent
In the "Translucent" setting the inserted stamp lies "beneath" the
existing drawing, which means that parts of the stamp can be
overwritten.
- Inverting
It is only the "Inverting" setting that allows both the drawing as
well as the stamp to be identified in the plot, because the over-
lapping areas are shown inverted.
• Stamp placement
This is where you fix the actual position of the stamp on the
drawing. The frame equates to the drawing, so that you can
choose from the entries for the nine positions from "top", "cen-
tered" to "bottom".
In addition, you can shift this fixed position in the field to the
right of it by a valid size unit. You set the currently valid size
units for RW-480 PLOTBASE in the configuration program and it
is displayed at the bottom of the screen in the status bar.
• Scale position
With the "Scale position" you determine whether the stamp al-
ways retains its position relative to the edge of the drawing
when the size is changed or whether the distance to the edge of
the drawing should be scaled too.
• Frame
Activate the "Enable frame" field if you want a stamp frame to
be printed. Three default settings can be set for the stamp
frame. Here too, the settings refer to the currently valid size unit,
which you can see in the status bar:
Upper setting - stamp border: With the upper of the three set-
tings you set the distance of the stamp to the edge of the draw-
ing.
Middle setting – stamp content: The middle setting gives the dis-
tance of the stamp content to the stamp frame.
Lower setting: The lower setting is used to fix the thickness of the
stamp frame.
RW-480 CLIENTS 49