Instruction manual

3700R/3740 Refrigerated Sampler
Section 2 Setup and Operating Procedures
2-6
Figure 2-6 Flow Meter Connection and Suction Line Port
Note
Install the bottle rack so that bottle number 1 is oriented
towards the front of the refrigerator.
2.5.2 Sample Bottle Rack
with 24 Sample Bottles
The sample bottle rack will hold either 24 round 350 ml, glass
sample bottles with Teflon lined caps or 24 wedge-shaped 1000
ml, polypropylene sample bottles with foamed-polyethylene lined
caps.
The glass bottles are held in place by a stainless steel retaining
ring installed inside the circle of bottles. The ring expands to
hold the bottles firmly against the interior of the wire rack. The
plastic bottles are held in place by a plastic, funnel-shaped
retaining ring that rests on top of the slanted portion of the
Suction Line
Port
Control Base
Thermostat
Knob
Flow Meter
Connector
Flow Meter
Cable
Power Cable
Flow Meter
Cable Port