Instruction manual

3700R/3740 Refrigerated Sampler
Section 3 Programming Guidelines
3-71
Enter head manually 242
NO
# of retries 243
0
Programming Mode 250
Select “EXTENDED.”
Load Stored Program 255
Load only a stored STORM program.
Save Current Program 260
Not applicable.
Flow Mode Sampling
Sample at start time 270
Disregarded by STORM routines.
Sample at switch times 271
Disregarded by STORM routines.
Nonuniform Time 280
Disregarded by STORM routines.
Calibrate Sampler 290
Select “DISABLE.”
Sampling Stop/resume 300
Sample at stop times 301
Disregarded by STORM routines.
Sample at resume times 302
Disregarded by STORM routines.
Start Time Delay 310
Enable Pin
Sample upon disable 321
Disregarded by STORM routines.
Sample upon enable 322
Disregarded by STORM routines.
Reset sample interval 323
Disregarded by STORM routines.
Inhibit countdown 324
Disregarded by STORM routines.
Event Mark
Continuous /pulse 330
Select preferred Event Mark.
Pump cycle/fwd only 331
Select preferred Event Mark.
Purge Counts
Pre-sample counts 340
Enter preferred count.
Post-sample counts 341
Enter preferred count.
Tubing Life
Reset pump counter 351
Reset if required.
# pump counts 352
Enter preferred count.
Program Lock 360
Select “ENABLE” or “DISABLE, “as preferred.
Sampler ID 365
Enter appropriate ID.
Run Diagnostics
No setting required.
Table 3-7 Recommended Configurations for Storm Sampling (Continued)
Configure Option Display Number Recommended Setting