Service manual

SCANNER 28 March 2006

3-12

The two actions above have the same objectives: to align the following holes.

scanner [D], frame [E], arm of second scanner [F], and frame [G]

The scanner positions are correct when these holes are all aligned.

Adjusting the Belt Contact Points for the First Scanner

• ADF or platen cover

• Front cover (☛ 3.2.1)

• Operation panel (☛ 3.2.2)

• Rear cover (☛ 3.2.3)

• Top rear cover (☛ 3.2.4)

• Left upper cover (☛ 3.2.4)

• Exposure glass (☛ 3.4.1)

1. Loosen the 2 screws [A] [F].

2. Slide the 1st and 2nd scanners to align the following holes and marks (☛

Overview):

• Align all four holes: 1

scanner, frame, arm of second scanner and frame

3. Insert the positioning tools [D] [E] through the holes.

4. Check that the scanner belts [B] [C] [G] [H] are properly set between the

bracket and the 1st scanner.

5. Tighten the screws [A] [F].

6. Remove the positioning tools.

7. Reassemble the machine and check the operation.

C267R905.WMF

[A]

[B]

[C]

[D]

[E]

[F]

[G][H]