Service manual

28 March 2006 SP6-10: MASTER WRITING SPEED
5-13
Service
Tables
No. Menu Items Default Settings
157 Paper front bulge A4 60rpm(Do not
Adjust)
0 -90 to 8
158 Paper front bulge A4 80rpm(Do not
Adjust)
0 -90 to 8
159 Paper front bulge A4 100rpm(Do not
Adjust)
0 -90 to 8
160 Paper front bulge A4 130rpm(Do not
Adjust)
0 -90 to 8
5.7.2 SP6-10: MASTER WRITING SPEED
1. Input SP8-10 (Test patterns) and enter “6”, then press the Start key.
2. Exit the SP mode, print 10 copies at 100 rpm (speed 2). Use the 10th print for
the adjustment.
3. The length of the 6 squares in the feed direction should be 130 mm, as shown
above.
4. If it is not, calculate the reproduction ratio using the following formula.
{(130 - Value) / 130} x 100 = ±
±±
± X.X % (Round off to one decimal place)
Example: If the value is 133, {(130 - 133) / 130} x 100 = - 2.3 %
5. Access SP6-10, input the calculated ratio, and press the Enter key.
6. Repeat the procedure to make sure that the ratio is correct.
130mm
8mm
C267S902.WMF