Operating instructions

Using Administrator Settings
171
9
Changing the User Parameters
Preparation
Access to some User Parameter
Settings requires installation of op-
tional equipment, or that other set-
tings be made beforehand.
Important
❒ It is recommended that you print
and keep a User Parameter list when
you program or change a User Pa-
rameter. See p.172 “Printing the
User Parameter List”.
❒ Do not change any bit switches other
than those shown on the previous
pages.
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Administrator Tools].
D Press [Parameter Setting].
E Select the switch number you want
to change.
F Select the bit number you want to
change.
When the bit number is pressed,
the current value switches between
1 and 0.
Note
❒ Repeat from step
F
to change
another bit number for the same
switch.
G Press [OK].
Note
❒ To cancel these settings, press [Can-
cel]. The display returns to that
of step
E
.
H Repeat steps
E
through
G
to change
the switch settings.
I After all the settings are finished,
press [Exit].
J Press the {User Tools/Counter} key.
The standby display appears.
AdonisC4-AE_Combine-F_FM.book Page 171 Thursday, May 12, 2005 3:15 PM