Operating instructions
Administrator Setting
160
9
F Press [Delete].
Note
❒ To cancel deleting, press [Do not
Delete]. The display returns to
that of step
E
.
G Press [Exit].
H Press the {User Tools/Counter} key.
The standby display appears.
Programming, Changing and
Deleting a Scan Size
When you select a scan size to scan a
custom size original, two custom siz-
es are available (Program Size 1 and
Program Size 2). Use these functions
to program a custom size in advance.
To change an existing scan size, just
use the same procedure.
Important
❒ When programming or changing a
scan size, it is recommended that
you make a record of the new size.
Note
❒ You can program up to two sizes.
❒ You can edit boxes in the same
way you program them.
❒ You can specify a horizontal length
from 128 to 1200 mm, or from 5.5 to
47 inches.
A Press the {User Tools/Counter} key.
B Press [Facsimile Features].
C Press [Administrator Tools].
D Press [Program / Change / Delete Scan
Size].
E Select [Program Size 1] or [Program
Size 2].
F Enter a horizontal size using the
number keys.
Note
❒ Each time you press [mm] or
[inch], the units switch between
“mm” and “inch”. If you enter a
length and change the units by
pressing [mm] or [inch], the
length is converted automati-
cally according to the unit (frac-
tions are rounded off). For example,
when you enter {2}, {2}, and
{0} in millimeters and change to
“inch”, the length “8.7 inch” is
shown on the display. If you
press [mm] or [inch] again, “221
mm” is displayed.
❒ If you make a mistake, press [Clear]
or the {Clear/Stop} key, and then
try again.
❒ To cancel a scan size, press [Can-
cel].
AdonisC4-AE_Combine-F_FM.book Page 160 Thursday, May 12, 2005 3:15 PM