Service manual

T echnical B ulletin
PAGE: 5/5
Model:
Bellini-C2 Date: 7-Nov-03 No.: RB070031
9. Plug in the connector for the anti-condensation heater to the AC drive board as shown
in Fig.1.
!CAUTION
All anti-condensation heaters are disconnected from the AC drive board
before shipping. Before plugging in the AC harness connector, make sure
that the main switch of the copier is switched off and the power cord
unplugged.
Note 1: The connector is hung on the clamp under the AC drive board.
Note 2: The tray heater is ON when the machine is in Auto Off Mode. (Main or operation
SW is OFF)
Fig.1 Fig.2
If you want the tray heater ON for 24 hours, disconnect the relay connector and set the
anti-condensation heater connector as shown in Fig.2
CAUTION: At this time, the heater is always ON when the power plug is connected with
the power source. Use caution when you do machine maintenance.