Service manual

T echnical B ulletin
PAGE: 4/4
Model:
Bellini-C2 Date: 7-Apr-03 No.: RB070001
5. Press the “Update (#)” key.
The firmware update will then begin, and the progress bar (*****___) will be displayed on
the operation panel.
The machine performs the firmware update in the following order:
“Network Support” # “System” # “BIOS” # “Ope Panel”
Note:
! While the “Ope panel” firmware is being updated, the panel display will be blank
(progress bar not displayed). Also, the Power ON LED will flash as follows:
- During the update: LED flashes on and off at
0.5s
intervals.
- After the update is completed: LED flashes on and off at
3s
intervals.
! It takes about 4 to 4.5 minutes to complete the “Ope panel” firmware update. The total
time for all four updates is about 8.45 minutes.
6. Turn the main switch OFF.
7. Remove the SD card from the C3 slot.
8. Turn the main switch ON.
9. Enter SP mode:
1. Press the Clear Modes key .
2. Press !"# on the operational panel keypad.
3. Hold down the Clear key
for more than 3 seconds.
4. Press Copy SP.
10.Check the firmware version to confirm that the firmware has been successfully
downloaded (SP7801):
!
Controller: B0705734B: V.1.04.4
!
NIC: B0705735B: V.4.03
!
BIOS: B0705742D: K02EL00O
!
LCDC: B0705371B (NA), B0705372B (EU): V.2.07
Note:
As mentioned above under Step 4, if the BIOS firmware could not be updated at the
same time (was not displayed), please repeat the above procedure to update the BIOS.
Important:
If the customer does not use a NetWare server, please change the “NetWare”
setting to “Invalid
”
in the User Tools.
User Tool --> System Setting --> Interface Setting --> Effective Protocol NetWare –>
Select “Invalid” –> Exit –> Main SW off/on