Service manual

1-6
11. Insert one end of the interface cable [A] to the connection PCB inserted in slot
A2.
12. If additional interface cables are required, connect the cables [B] with the
repeater hubs [C]. (☛1.3.2)
13. On the operation panel of the both machines, remove the second cover (or
Printer key) from the bottom [D].
14. Install an appropriate key for each machine:
Attach the “Printer/Other Function” key [E] (or its equivalent symbol keytop for
EU) if the printer/scanner option is installed in the machine.
-or-
Attach the “Other Function” key [E] (or its equivalent symbol keytop for EU) if
the printer/scanner is not installed in the machine.
15. Attach the other end of the connection cable to the connection PCB installed in
the other machine.
16. The following software must be downloaded onto both the master and slave
machine.
• SYSTEM Ver. V3.04.1(install first) or later
•
NCS (NIB) Ver. 4.13.3 or later
• NetFile Ver. 3.04.2 or later
• BCU (Engine) V4.01.1 or later
•
LCDC (NA, EU) Ver. 2.09 or later
NOTE:
For details about downloading procedures, see Section “5. Service
Tables” of the Service Manual.
T03040804.WMF
[A]
[B]
[C]
[D]
[E]