Service manual

1-4
Installation Procedure
!
CAUTION
Switch the machine off and unplug the machine before starting the
following procedure.
1. Switch the main power switch off.
2. Remove the controller box cover. (
!
x7)
3. Remove the cover [A] from slot A2.
4. Align the PCB with the bottom groove, and push the connection PCB [B] into
the slot.
NOTE: Make sure that the edge of the PCB is in the groove before you push
the card into the machine.
5. Fasten the PCB with the attached screws [C].
T03040802.WMF
[A]
[B]
[C]