Service manual

– 12 –
Please keep the following important points in mind when you are doing this setting:
• Note that the number entries for Keys 1 to 5 are the same for the Copy, Printer, Scanner,
and Web memory modules.
• The initial settings are all zero.
•
These settings remain in effect until you change them. Be sure to check all the settings,
especially the settings for Keys 6 to 10. To switch off a key setting, enter a zero for that
key.
• You can select any number of keys from 1 to 10 (or all) by entering the corresponding 4-
digit numbers from the table.
• You cannot mix settings for the groups (COPY, PRINTER, etc.) for 006~010. For
example, if you want to create a PRINTER debug log you must select the settings from
the 9 available selections for the “PRINTER” column only.
• One area of the disk is reserved to store the debug log. The size of this area is limited to
4 MB.