Service manual

– 8 –
5. Service Tables
Pg. Old New/Action
5-23
SP3903
Adjusts the starting point for the VD
Correction. Displays whether the
VD correction is being performed.
The target value for VD correction
is “the value of SP2-001-7 + 50”.
[0~999 /
200
/ 1 K copies]
DFU
Adjusts the starting point for the VD
Correction. Displays whether the VD
correction is being performed. The target
value for VD correction is “the value of SP2-
001-7 + 50”.
[0~999 /
200
/ 1 K copies]
(Not DFU)
5-24 SP number for “Scanner Free Run” is
not mentioned.
SP4013
Scanner Free Run
5-25 SP number for “SP4013 Scanner
Speed Adjustment” is incorrect.
SP4015
Scanner Speed Adjustment
5-49
SP5857 002
Under normal conditions, select “3”.
Use “2” only if the HDDs have been
removed.
Deleted the description.
5-128 to 133 Deleted “Using the Debug Log” Completely revised and replaced based on
new information. Please refer to the new text
below.
<< New >>
5.16 Using the Debug Log
This machine provides a Save Debug Log feature that allows the Customer Engineer to
save and retrieve error information for analysis.
Every time an error occurs, debug information is recorded in volatile memory but this
information is lost when the machine is switched off and on.
The Save Debug Log feature provides two main features:
•
Switching on the debug feature so error information is saved directly to the HDD for later
retrieval.
•
Copying the error information from the HDD to an SD card.
When a user is experiencing problems with the machine, follow the procedure below to set
up the machine so the error information is saved automatically to the HDD.
5.16.1 Switching On and Setting Up the Save Debug Log function
The debug information cannot be saved the until the “Save Debug Log” function has been
switched on and a target has been selected.
1. Enter the SP mode and switch the Save Debug Log feature on.
• Press # then use the 10-key pad to enter $%&.
• Press and hold down
'
for more than 3 seconds.
•
Touch “Copy SP”.
• On the LCD panel, open SP5857.