Service manual

– 2 –
Installation Procedure
" CAUTION
Switch the machine off and unplug the machine before starting the
following procedure.
1. Switch the main power switch off.
2. Remove the controller box cover. (! x7)
3. Remove the cover [A] from slot A2.
4. Align the PCB with the bottom groove, and push the connection PCB [B] into the slot.
NOTE:
Make sure that the edge of the PCB is in the groove before you push the card
into the machine.
5. Fasten the PCB with the attached screws [C].
T03040802.WMF
[A]
[B]
[C]