Service manual

T echnical B ulletin
PAGE: 4/5
Model:
Bellini-C2 Date: 24-Apr-03 No.: RB070003
5852 007 POP before SMTP
A flag that determines whether the POP
server is connected before connecting to
the SMTP server.
[0~1 / 0 / 1]
POP
0: OFF
1: On
Post Office Protocol (POP) servers are
computers that receive mail using SMTP.
The mail includes a setting to ensure that it
is directed to the POP server. POP servers
are used when the user is not permanently
connected to the Internet.
008 POP Server Name
Sets the POP server name.
009 POP Port Number Sets the POP port number.
[1～65535/
110
/1]
010 POP User Name
Sets the POP user name.
011 POP Password
Sets the POP password.
012 POP Auth. Encryption Sets the encryption method for the
password when 5852 POP Before SMTP
is in use.
[0~2 / 0 / 1]
0: Auto. Allows two methods for
encryption: APOP and normal
encryption to match the settings of
the POP server.
1: Off. Allows only normal encryption.
2: On. Allows only APOP encryption.
013 Time out Setting for POP
Sets the wait time after POP validation
until the SMTP mail is sent.
[0~10000/
300
/1 ms]
<< Procedure for Firmware Update and Manual Input of New SP Defaults >>
After updating the firmware, it is necessary to manually set some of the new SP modes to
their new defaults. This is necessary not only to enable SMTP authentication, but also to
prevent errors that can occur with the Scan to e-mail function while the values above are
still at “0”.
To set SP5852-003 to 013 to their new defaults:
1. Print out the NIB summary report (SP5-990-007).
2. Update the firmware to the versions specified above.
3. Check that the SMTP server name displayed in the following screen is the same as
the name on the NIB summary report:
User Tools # System Settings # File transfer Tab.