Service manual

T echnical B ulletin PAGE: 1/2
Model: Bellini-C2 Date: 10-Apr-07 No.: RB070068
Subject: Patch Release for EB-105EX V.1.2 (1-PH0HL) Prepared by: Chisato Tsuji
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
This RTB is the release note for Patch File 1-PY0HL for EB-105EX printer controller
System V1.2.
Patch File Issue(s)
1-PY0HL z Some pages are skipped when printing a multi page job and when
there is a paper jam.
Note:
z This patch is only for EB-105EX System Version 1.2.
Prerequisite(s):
z Before this patch is applied, the following patches should already be applied on the
system in the following order.
1-HASH8.ps (If the FPGA revision is already 20, then this patch is not needed)
1-LV4GA.ps
1-N69ZD.ps
1-N522T.ps
1-OT69U.ps
1-MMWR9.ps
1-Q3WG8.ps
Patch Update Procedure
1. Print out the configuration page and confirm that the prerequisite patches are already
installed on the system software v.1.2.
(If not, install the prerequisite patches first.)
2. Extract the G3538992.exe until you get the 1-PY9HL.ps file.
3. Use the Fiery Downloader to download the patch file (1-PY9HL.ps) to the Direct queue.
4. Wait at least 60 seconds.
Note: This is very important
.
5. Reboot the EB-105EX.
z “Fiery” menu Æ “Shut Down” Æ “Reboot System”
6. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.
7. Print out the Configuration Sheet.