Service manual

Technical Bulletin PAGE: 1/2
Model: Bellini-C2 Date: 28-Dec-06 No.: RB070063
Subject: Patch Release for EB-105EX V.1.2 (1-N522T) Prepared by: Chisato Tsuji
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
This RTB is the release note for Patch File 1-N522T for EB-105EX printer controller
System V1.2.
Patch File Issue(s)
1-N522T 1) During a large print job, a blank page is inserted in the job if the
paper is fed from multiple trays due to an out-of-paper condition.
Note:
l This patch is only for EB-105EX System Version 1.2.
Prerequisite(s):
l Before this patch is applied, the following patches should already be applied on the
system in the following order.
1-HASH8.ps (If the FPGA revision is already 20, then this patch is not needed)
1-LV4GA.ps
1-N69ZD.ps
Patch Update Procedure
1. Print out the configuration page and check that the prerequisite patches are already
installed on the system software v.1.2.0.
(If not, install the prerequisite patches first.)
2. Extract G3538982.exe until you get the 1-N522T.ps file.
3. Use the Fiery Downloader to download the patch file (1-N522T.ps) to the Direct queue.
4. Wait at least 60 seconds.
Note: This is very important.
5. Reboot the EB-105EX.
l “Fiery” menu à “Shut Down” à “Reboot System”
6. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.
7. Reboot the EB-105EX again.
Note: This step is necessary to apply the new patch.
8. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.