Service manual

T echnical B ulletin PAGE: 1/2
Model: Bellini-C2 Date: 6-Sep-06 No.: RB070061
Subject: Waste Toner Clogging Prepared by: M.Matsuda
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
Important Notes on Preventing Waste Toner Clogging
1. The next time you remove the development unit from the machine for maintenance,
make sure the drive gears are engaged correctly.
CORRECT
Note: If the drive gears are engaged correctly, the end of the coil will be in the position
shown by the red circle in the photo below.
Incorrect