Service manual

Technical Bulletin PAGE: 4/4
Model: Bellini-C2 Date: 10-Aug-06 No.: RB70060
Version Symptom Corrected
used without performing SP5832-001 (HDD Initialization).
5. SC819 sometimes occurs when a defective HDD sector is detected.
6. SC818 sometimes occurs when a relatively large print job is sent via a USB
connection.
A 1. The pre-set (new) job sometimes does not start when the Reverse Job
Setting is set to “Previous Job.” (Note: This setting is in Copier/Document
Server Features in UP mode).
2. The Key Counter is not enabled when the operation switch is turned Off/On.
3. The machine cannot make the booklet on Print jobs when the Plockmatic
(SR90) is installed.
4. Part of the image is cut off if: 1) Palm2 captures the image from the document
server, and 2) the image was enlarged when it was saved from the EFI
controller.
5. SC990 occurs when the operator prints out a Document Server file that is
over 120 pages with Designated Copy/Print.