Service manual

Technical Bulletin PAGE: 3/4
Model: Bellini-C2 Date: 10-Aug-06 No.: RB70060
Version Symptom Corrected
14. Image is not printed out correctly if Interrupt Copy is used while printing out a
Document Server file.
Specification change:
Estimated job completion times added to New Job table for the Printer function.
C 1. Modified for use with the EB-105EX controller (EFI).
2. Error in storing debug log data when the function is set for engine log storage
(2224) of paper jams.
D 1. Modified for simultaneous use of the EB-105EX with Desk Top Editor for
Production.
2. The image is sometimes positioned incorrectly when printing a file from the
Document Server to custom-sized paper using Double Copies and
Centering/Cornering.
3. 32k bytes of a scanned image is sometimes lost on the trailing edge.
4. The image is sometimes printed in the wrong orientation when Reserve Job is
set to “Previous Job” and the paper type for the selected tray is set to “Tab
Stock”.
5. The “Please Wait” display does not clear if the HDD installed is defective.
6. SC819 sometimes occurs with Copier Connector mode.
7. 1200dpi image data sometimes does not appear correctly after being
transferred from the MFP hard drive to Desk Top Editor for Production (or
vice-versa).IMPORTANT: To ensure the above do not occur, it is also
necessary to update to the following firmware versions or newer:
Netfile V.3.08 (B0705756D)
E 1. Modified for use of the EB-105EX in combination with Desk Top Editor for
Production.
2. SC955 may occur when printing out a Document Server file from the
operation panel in Magazine mode if the file 1) contains blank page(s), and 2)
was originally stored to the Document Server via a GW controller.
3. SC672 may occur on units with an MLB installed when storing a file
containing blank page(s) to the Document Sever via a GW controller.
4. When retrieving a stored copier document at the same time as sending a print
job, an SC955 error occurs.
5. Sometimes, JPEG 2000 images cannot be retrieved by the Desk Top Editor
for Production from the MFP HDD.
6. The EB-105EX stalls if turned Off/On more than 100 times while the Bellini-
C2 main power is on (memory control related).
IMPORTANT: To ensure the above do not occur, it is also necessary to
update to the following firmware versions or newer:
Netfile V.3.09 (B0705756E)
B0705774
IMPORTANT NOTE: Refer to RTB RB070039 at the firmware installation
1. Firmware modified for upgrade to the Bellini-C2e (enhanced version) by
supporting use with the Z-fold unit and Victoria-D (B076).
2. The number of holes for Punching returns to its default when the Plockmatic
Booklet Maker is connected.
3. New SP added: SP2115-007 (details: see RTB #RB070038).
4. Documents stored in the HDD and other data such as Address Book entries
are sometimes deleted at main power off if a new HDD is installed and then