Service manual

T echnical B ulletin
PAGE: 1/1
Model:
Bellini-C2 Date: 7-Jan-05 No.: RB070057
Subject:
Patch Release for EB-105EX V.1.2 (1-GYWYK)
Prepared by: Chisato Tsuji
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
This RTB is the release note for Patch File
1-GYWYK
for EB-105EX printer controller
System V1.2.
Patch File Issue(s)
1-GYWYK
When doing Rip & Hold for some multiple copy data to print, the
printing process never completes.
Note:
This patch is only for EB-105EX
System Version 1.2
.
Please make sure that patches “1-FY60I” and “1-GRRLM” have already been applied to
System V.1.2 before installing this new patch.
Patch Update Procedure
1. Use the Fiery Downloader to download the patch file (1-GYWYK.ps) to the Direct
queue.
2. Wait at least 60 seconds.
Note:
This is very important
.
3. Reboot the EB-105EX.
 “Fiery” menu  “Shut Down”  “Reboot System”
4. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.
5. Reboot the EB-105EX again.
Note:
This step is necessary to apply the new patch.
6. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.
7. Print out the Configuration Sheet.
8. Make sure that patch number 1-GYWYK is listed in the “Update Information” section of
the Configuration Sheet.