Service manual

T echnical B ulletin
PAGE: 1/1
Model:
Bellini-C2 Date: 7-Jan-05 No.: RB070056
Subject:
Patch Release for EB-105EX V.1.2 (1-GRRLM)
Prepared by: Chisato Tsuji
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
This RTB is the release note for Patch File
1-GRRLM
for EB-105EX printer controller
System V1.2.
Patch File Issue(s)
1-GRRLM
Every sheet is offset when a job is printed using the tab setting.
Note:
This patch is only for EB-105EX
System Version 1.2
.
Please make sure that the patch “1-FY60I” has already been applied to System V.1.2
before installing this new patch.
Patch Update Procedure
1. Use the Fiery Downloader to download the patch file (
1-GRRLM.ps
) to the Direct
queue.
2. Wait at least 60 seconds.
Note:
This is very important
.
3. Reboot the EB-105EX.
 “Fiery” menu  “Shut Down”  “Reboot System”
4. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.
5. Reboot the EB-105EX again.
Note:
This step is necessary to apply the new patch.
6. Wait until “EB-105EX” is displayed on the EB-105EX LCD panel.
7. Print out the Configuration Sheet.
8. Make sure that patch number 1-GRRLM is listed in the “Update Information” section of
the Configuration Sheet.