Service manual

T echnical B ulletin
PAGE: 1/1
Model:
Bellini-C2 Date: 5-Oct-04 No.: RB070049
Subject:
Patch Release for EB-105EX (1-EG91P)
Prepared by: Chisato Tsuji
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
This is a release note for a patch file for printer controller EB-105EX.
Patch File Issue(s)
1-EG91P This patch corrects the following:
• When repeatedly canceling jobs on CWS, SC919 happens.
Important Note:
This patch file is for application to the EB-105EX System v1.01.
Patch Procedure for 1-EG91P.ps
1. Confirm that the following patches are already installed by checking to see if it is listed
in the “Update Information” section of the configuration sheet. If it is not, apply these
patches before going on to Step 2.
! Patches: “1-AKVJG”, “1-9ZUYT”, “1-CX7BV”, “1-D3C5T”, “1-B952E_1-BWIKW +
1-DPK09”, “1-DBI62”, “1DWZRP”.
2. Download the new 1-EG91P.ps patch listed above to the
Direct queue
using the Fiery
Downloader.
3. Wait at least 60 seconds.
Note: It is very important to wait at least this long before continuing.
4. Reboot the system (Fiery Menu
# Shut Down # Reboot System).
5. Print out the configuration sheet once the EB-105EX has completely warmed up and
reached ready status.
6. Confirm that the 1-EG91P.ps patch has been successfully installed by checking to see
that it is listed in the “Update Information” section of the configuration sheet.