Service manual

T echnical B ulletin
PAGE: 12/15
Reissued: 15-Apr-05
Model:
General RTB
Date:
15-Nov-04
No.:
RGene019a
6. ERROR RECOVERY
There are three ways to recover from a loss of power during RFU.
6.1 Recovery Procedure
There are three types for recovery after a power loss during RFU. (This will depend on
the firmware and model). Procedures for types 1, 2 and 3 are on the next page.
Find the firmware and model you are downloading to, and begin with the type
shown
in the table below.
Recommendation:
As mentioned in 5. Updating Procedure, it is strongly recommended that RFU be
performed on-site, to minimize the chances of a power-down during RFU.
Printers
Model System Network WebSys Printer Engine Card Type
Model J-P2 Type1 Type1 --- Type1 Type1 IC
Model J-P2CF Type1 Type1 --- Type1 Type1 IC
Model K-P3 Type1 Type1 Type1 Type1 IC
Model C-P1 Type1 Type1 Type1 Type1 IC
Model J-P3 Type1 Type3 Type3 Type3 Type1 SD
Model PL-P1 Type1 Type1 Type1 Type1 N/A SD
Model G-P1 Type1 Type1 Type1 Type1 Type1 SD
Model C-P2 Type1 Type1 Type1 Type1 Type1 SD
Model K-P4 Type1 Type1 Type1 Type1 Type1 SD
MFPs
Model System Network WebSys Printer PS Engine Card Type
Model A-C3e/f Type2 Type2 Type2 Type2 Type2 Type1 IC
Model R-C3 Type2 Type2 Type2 Type2 Type2 Type1 IC
Model K-C2 Type1 Type1 Type1 Type3 Type3 Type3 SD
Model S-C2 Type1 Type1 Type1 Type3 Type3 Type1 SD
Model B-C2e Type2 Type2 Type2 Type3 Type3 Type3 SD
Model J-C1 Type1 Type1 Type1 Type3 Type3 Type1 SD
Model MT-C2 Type2 Type2 Type1 Type1 Type1 Type1 SD
Fig. 3 Recovery Method