Service manual

T echnical B ulletin
PAGE: 7/8
Model:
Bellini-C2 Date: 21-Apr-03 No.: RB070002
7. System Requirements
7-1 SD CARD
Please read over the important notes described below regarding the handling of the SD card. If
these points are not followed carefully, it may cause the card to be damaged or data to be lost.
Important Notes:
•
Do not directly touch the card contacts or bring them into contact with a metallic
substance.
•
Do not bend, drop or apply any force or shock to the card.
• Keep the card dry at all times, avoiding high-humidity environments and making sure
condensation does not form on the card. The environmental requirements for operation
and storage are as follows:
During operation: Storage:
Temperature 0 to 55
o
C -20 to 65
o
C
Humidity 20 to 85%RH 5 to 85%RH
• Do not remove the card or turn the power off while reading or writing data.
•
All SD cards come preformatted. However, if reformatting the card later on for some
purpose, always be sure to confirm the contents of the card before doing so, as all data
will be lost when the card is reformatted.
• Do not attempt to duplicate or reformat an application SD card.
Other:
• The power should always be OFF before the card is inserted in or removed from the
machine (see Service Manual for details).
• The SD card should always be kept in the plastic case to protect it from damage.
• No labels should be affixed to the card except for the ones packaged together with the
card. This label must be affixed in the correct position, and must always be removed
when attaching a new label (labels must not be stacked).
• If writing on the label, always do so before affixing it to the card.
• Before inserting either the service or application SD card, always make sure that the card
switch is unlocked, as using them in the locked condition will cause an error.
• Since the application SD card is formatted in a different way from the service SD card, the
application card cannot be used as a service tool.