Service manual

T echnical B ulletin
PAGE: 4/15
Reissued: 15-Apr-05
Model:
General RTB
Date:
15-Nov-04
No.:
RGene019a
5. UPDATING PROCEDURE
Recommendation:
It is strongly recommended that RFU be performed on-site, to minimize the chances of a
power-down during RFU.
5.1 Auto Rebooting
After receiving new firmware, the machine firmware is updated and the machine is
automatically rebooted using the updated firmware. Fig.2 shows the kind of reboot
required after the firmware is updated.
Printers
Model System Network WebSys Printer Engine
Model J-P2 Auto Auto --- Auto Auto
Model J-P2CF Auto Auto --- Auto Auto
Model K-P3 Auto Auto Auto Auto
Model C-P1 Auto Auto Auto Auto
Model J-P3 Auto Auto Auto Auto Auto
Model PL-P1 Auto Auto Auto Auto N/A
Model G-P1 Auto Auto Auto Auto Auto
Model C-P2 Auto Auto Auto Auto Auto
Model K-P4 Auto Auto Auto Auto Auto
MFPs
Model System Network WebSys Printer PS Engine
Model A-C3e/f Auto Auto Auto Auto Auto Manual
Model R-C3 Auto Auto Auto Auto Auto Manual
Model K-C2 Auto Auto Auto Auto Auto Auto
Model S-C2 Auto Auto Auto Auto Auto Auto
Model B-C2e Auto Auto Auto Auto Auto Auto
Model J-C1 Auto Auto Auto Auto Auto Auto
Model MT-C2 Auto Auto Auto Auto Auto Auto
Fig. 2 Reboot Method
Auto: Automatically rebooted after updating the firmware.
Manual: The machine must be manually rebooted after updating the firmware.