Service manual

T echnical B ulletin
PAGE: 1/1
Model:
Bellini-C2 Date: 14-May-04 No.: RB070044
Subject:
Patch Release for EB-105EX (1-B952E_1-
BWIKW)
Prepared by:
Chisato Tsuji
From: 2nd Tech Support Sec. Service Support Dept.
Classification:
Troubleshooting
Mechanical
Paper path
Part information
Electrical
Transmit/receive
Action required
Service manual revision
Retrofit information
Other ( )
This is a release note for a patch file for printer controller EB-105EX.
Patch File Issue(s)
1-B952E_1-
BWIKW
This patch will correct the following errors when the Plockmatic finisher
is connected.
•
Pages are output in the incorrect order when selecting Booklet
Staple in the PCL driver and printing out to the Plockmatic finisher.
•
The rear side on some sheets is not printed if the Cover Inserter
used with the Plockmatic reaches the paper end condition.
•
The print job sometimes cannot be completed if the Cover Inserter
used with the Plockmatic reaches the paper end condition.
Note: This patch is for EB-105EX system version 1.01.
Please make sure that patches “1-AKVJG”, “1-9ZUYT”, “1-CX7BV” and “1-D3C5T”are
already applied to the System version 1.01 before this patch is applied.
Patch Procedure for 1-B952E_1-BWIKW:
1. Download the patch file (1-B952E_1-BWIKW.ps) to the Print queue by using
the “Fiery Downloader”.
2. Wait for more than 60 seconds. (Very important)
3. Reboot the system.
(Access the Fiery menu, select “Shut Down” and then “Reboot System”.)
4. When the EB-105EX becomes idle, print the configuration sheet.
5. Check if you can see the patch number “1-B952E_1-BWIKW.ps” in the
"Update Information" section on the configuration sheet.