Service manual

T echnical B ulletin
PAGE: 6/15
Model:
Bellini-C2 Date: 4-Feb-04 No.: RB070038
003 Back – On/Off Setting Switches the PTL on and off for the rear side of the
paper passing through the fusing unit in the duplex
mode at normal speed.
[0~1/0/1]
0: Off
1: On
Note:
•
When this setting is switched on, make sure that the
setting of SP2940 008 is the same as the default
setting of SP2940 001.
•
When feeding thick paper or OHP transparencies,
this setting is always off.
004 Back – On/Off Timing Adj. This SP adjusts the length of the space from the
leading edge where the PTL quenching is applied to the
rear side at normal speed. For example, if you set +5, 5
mm from the leading edge will be quenched.
[-5~10/2/0.1 mm]
005 Front – On/Off Setting:
Low Speed Mode
Switches the PTL on and off for the front side of the
paper passing through the fusing unit in the low speed
mode.
Note: When feeding thick paper or OHP
transparencies, this setting is always off.
[0~1/0/1]
0: Off
1: On
006 Front – Off Timing Adj.:
Low Speed Mode
This SP adjusts the length of the space from the
leading edge where the PTL quenching is applied to the
front side in low speed mode. For example, if you set
+5, 5 mm from the leading edge will be quenched.
[-5~10/2/0.1 mm]
007 Back– On/Off Setting:
Low Speed Mode
Switches the PTL on and off for the rear side of the
paper passing through the fusing unit in the duplex
mode in low speed mode.
[0~1/
0
/1]
0: Off
1: On
Note:
• When this setting is switched on, make sure that the
setting of SP2940 016 is the same as the default
setting of SP2940 009.
• When feeding thick paper or OHP transparencies,
this setting is always off.
008 Back – Off Timing Adj.:
Low Speed Mode
This SP adjusts the length of the space from the
leading edge where the PTL quenching is applied to the
rear side in slow speed mode. For example, if you set
+5, 5 mm from the leading edge will be quenched.
[-5~10/
2
/0.1 mm]