Service manual

T echnical B ulletin
PAGE: 5/15
Model:
Bellini-C2 Date: 4-Feb-04 No.: RB070038
b)
Finisher Input Check: SP6117.
The sensors in bold have been added.
Reading
Class
3
No.
Bit
No.
Description
0 1
7 Not Used
6 Shift Tray Full Sensor – Z-folding Not full Full
5 Bottom Fence HP Sensor Not home position Home position
4 Top Fence HP Sensor Not home position Home position
3 Emergency Stop Switch Not pressed Pressed
2
Shift Jogger Lift HP Sensor
(Optional Jogger Unit)
Home position Not home position
1
Shift Jogger HP Sensor (Optional
Jogger Unit)
Not home position Home position
6
0 Optional Jogger Unit Connection Connected Not connected
c) Finisher Output Check: SP6118
The motors in bold have been added.
26 Jogger Top Fence Motor
27 Jogger Bottom Fence Motor
III. Other SP Modes
1) Pre-transfer Lamp (PTL)
The following SP modes have been newly added for PTL settings.
Note: This PTL is intended to as a countermeasure for poor drum separation. But as a
side effect, blurred images may appear on the leading edge of the paper. The
default of the PTL setting is therefore “Switch Off.”
SP2602 PTL Settings
001 Front – On/Off Setting Switches the PTL on and off for the front side of the
paper passing through the fusing unit at normal speed.
Note: When feeding thick paper or OHP
transparencies, this setting is always off.
[0~1/0/1]
0: Off
1: On
PTL timing can be adjusted with SP2602 002.
002 Front – Off Timing Adj. This SP adjusts the length of the space from the
leading edge where the PTL quenching is applied to the
front side at normal speed. For example, if you set +5,
5 mm from the leading edge will be quenched.
[-5~10/2/0.1 mm]