Installation & Assembly

1. Center sink, and trace outline of sink on ountertop

using pencil, Proceed to use this outline as guide for

cutout, and cut the cabinet to ﬁt the kitchen sink

Fine Fixtures recommends Under-Counter sink installation. While ﬂush-mount or built-up installation is possible, we don’t recommend it.

With all installations, be sure to allow adequate space for faucet and backsplash installations.

Under Counter/Solid Surface Installatio: As mentioned, Farmhouse sinks may require custom cabinetry, and we recommend

that you consult an experienced cabinetmaker to achieve a perfect ﬁt.

IV. Installation Options

V. Template and Cutout

2. Build support frame or install support bars from

front to back along inner cabinet sides. Cut 2

pieces of 2 x 4 beams to ﬁt inside the cabinet. and

a plywood board that will sit on top of the beams.

3. Position support frame so that, when installed, sink

is in line and level with top of cabinet. we recommend

that you screw the beams with wood glue and screws,

Keep in mind that frame must support weight of sink

and all its attachments.

4. Attach the beams into place with wood glue,

allow enough time for the glue to dry then fasten

the beams with wood screws into the cabinet.

5. Cut-out the sections where your drain and faucet

lines will be, ﬁt the board on top of the beams and

verify that it is leveled, If not leveled, adjusted with

shims

6. Place the board on the beams, Secure the board

to the beams with screws. Verify the board is still

leveled, and place the sink over the plywood..

Ensure proper clearance for water supply lines,

drains and garbage disposal, if applicable.