Installation Guide

ULD Reader Installation
ULD Reader InstallationULD Reader Installation
ULD Reader Installation
ULD Reader Installation Guide
ULD Reader Installation GuideULD Reader Installation Guide
ULD Reader Installation Guide 2-7
2-72-7
2-7
Reader Bracket Installation for Workstations
This activity consists of removing the existing bracket and installing the
Reader Bracket (bracket) at Workstations 1 through 12.
You must perform the procedure, “Removing Deck Plates” on page 2-4
before performing this procedure.
Note: The existing brackets at the Workstation locations (1 through 12)
are welded into place.
•To remove the existing bracket and install the Reader Bracket for
Workstations 1 through 12:
1. Remove the existing brackets using an acetylene torch or grinder operated
by a qualified on-site welder.
Heat Shields must be placed between the mounting bracket and the
bearings that support the rollers, to avoid Roller Bearing damage.
2. After the existing bracket has been removed, inspect the bracket
mounting holes for any dimension and concentricity anomalies.
3. If required, hand-grind the bracket mounting surface smooth.
4. Clean the bracket mounting surface and mounting holes with Xylene,
then wipe with alcohol.
5. Place the Reader Bracket in position with two (2) mounting bolts.