Installation Guide

ULD Reader Installation
ULD Reader InstallationULD Reader Installation
ULD Reader Installation
ULD Reader Installation Guide
ULD Reader Installation GuideULD Reader Installation Guide
ULD Reader Installation Guide 2-5
2-52-5
2-5
•To remove the existing bracket and install the Reader Bracket for TTTV,
ETV, and BV:
1. With open-end and adjustable wrenches, remove the U-bracket from the
roller suspension rail.
2. Inspect the bracket mounting holes for any dimension and concentricity
anomalies.
3. If required, hand-grind the bracket mounting surface smooth.
4. Clean the bracket mounting surface and mounting holes with Xylene,
then wipe clean with alcohol.
5. Place the Reader Bracket in position with (2) mounting bolts.
Figure 2-3 Reader Bracket and Mounting Bolts
6. Attach a lock washer and nut on each bolt and hand tighten.
7. Attach the Bracket Mounting Fixture to the Reader Bracket, using
Retaining Bolt “A” (m10 - 1.5 carriage bolt).