Installation Guide

ULD Reader Installation
ULD Reader InstallationULD Reader Installation
ULD Reader Installation
2-4
2-42-4
2-4 ULD Reader Installation Guide
ULD Reader Installation GuideULD Reader Installation Guide
ULD Reader Installation Guide
Bracket Removal and Installation
Deck plates are removed before installation procedures are performed.
Installation procedures include:
•Reader Bracket Installation for TTTV, ETV, and BVon page 2-4
•Reader Bracket Installation for Workstations on page 2-7
Removing Deck Plates
•To remove a deck plate:
1. Determine the mounting location of the Reader (see “Reader Locations”
on page 2-18).
2. As required, remove two Allen or flat-head screws from each end of the
deck plate (four screws total).
3. Using a pry bar, loosen the deck plate and lift straight up, until the plate is
free of existing brackets.
Make sure that personnel are stationed at each end of the deck plate while
you perform this step.
4. Avoiding contact with rollers, lift and remove the deck plate.
Store the deck plate for later use.
5. Inspect existing brackets and bracket mounting holes for dimensional and
welding anomalies.
Reader Bracket Installation for TTTV, ETV,
and BV
This activity consists of removing the existing bracket and installing the
Reader Bracket (bracket) for TTTV, ETV and BV locations.
You must perform the procedure, “Removing Deck Plates” on page 2-4
before performing this procedure.